Following up to my Youtube video, i'd though i share my post-installation experiences.
When starting the car, you will notice that the OEM temperature gauge is moving, but the Prosport water temperature gauge will be still. The gauge will start moving when the car's gauge will be almost at operating temperature. At approximately the same point, the oil temperature gauge will also start moving.
After the car is at full operating temperature, give it some gas, and then rev it to 9000 rpm, and make sure that the oil pressure gauge does not exceed 6 bar or 80PSI.
The max Oil temperature must not exceed 100°C/210F.
Water temperature under heavy load, must not exceed 100°C/212F.
When i started the car and let it idle, the water temperature gauge went all the way to 104°C and started flashing and beeping. I check the temperature on my OBD2 scanner, and it showed that my peak temperature was 98°.
I suspect that the water temperature gauge is out of calibration, and there is a way to calibrate it, so make it show the actual temperature. I'll post the tutorial once i get it done.
I also left out 3 swires (like the main power ones, red,orange,white,black) that i had no idea where to connect.
If any of you guys have experience with these gauges, feel free to comment :)
Hiii, How do I mute the Gauges? Cuz my Water Temp is flashing and beeping at 95°C and thats kinda annoying. Is there a n extra Wire for the beeper or is there a Permanent mute button? Thanks :)